Fujitsu Ricoh Fujitsu N7100E Network Image Scanner - Manual (Page 52)

2.2 Using the Scanner Buttons
52
(*2):  When the scanner power button is pressed while a window displaying the
[Shutdown] button is shown, the "Please release the power button and select
shutdown to turn the scanner off." message appears.
 When the scanner power button is pressed while a window not displaying the
[Shutdown] button is shown, the "Please release the power button. Can not
shutdown scanner because the system is in operation." message appears.
(*3): If [Turn off the display only] is set for [Standby Mode] on the administrator
window, only the display turns off. The power button stays lit up.
ATTENTION
 When the scanner is running or in standby mode, do not hold down the power button for 4
seconds or longer, as it may cause the scanner to shutdown. If this happens, saved scanned
data may become unusable.
If you hold down the power button for 4 seconds or longer and the scanner is shutdown,
remove the AC cable to ensure that the power is completely off.
 After turning the power off, wait for at least 10 seconds before turning the power back on
again. To shutdown the scanner correctly, press the [Shutdown] button on the window.
HINT
 If the scanner is left in standby mode until the time set for [Power-off after], the power of the
scanner is automatically turned off. Note that if this occurs, it takes time to turn the scanner
on again.
 The time to enter standby mode and to power off the scanner can be changed. For details,
refer to
"4.6.3 Setting the Standby Mode" (page 95) .
 Automatic login without displaying the [Login] window is possible. For details about how to
set automatic login, refer to
"4.6.1 Setting the Login Settings" (page 90) .
 If automatic login is set, login via the Admin Tool is possible while the main menu or job menu
is displayed.