Fujitsu Ricoh Fujitsu N7100E Network Image Scanner - Manual (Page 364)

7.2 Network Connection Troubleshooting
364
7.2 Network Connection Troubleshooting
If a network connection is not possible, first check the scanner status and system settings.
The following section provides information about general troubles that may occur when
connecting to a network.
If the cause of the problem is unknown or the problem persists, check the items in
"7.4
Points to Check before Contacting Your Distributor/Dealer" (page 388) and contact the
distributor/dealer where you purchased this product.
7.2.1 Basic Network Operation Tests
After the network has been setup, perform the following network operation tests on the
administrator window.
 Checking basic network operation with a Ping test
 Checking the network operating status
 Checking the NTP server settings by synchronizing the system time (if using an
NTP server)
 Checking the mail server by sending a test mail (if scanned data is to be sent as an
e-mail, by fax, or when requesting alert notifications by e-mail)
■ Checking Basic Network Operation with a Ping Test
Check the network connection status of the following computers and servers associated
with the network.
For details about the checking procedure, refer to
"4.8.1 Checking the Network
Connection with a Ping Test" (page 108) .
 Computer with Admin Tool installed
 Computer with Central Admin Console installed
 Computer with Central Admin Server software installed
 Computer with User Editor installed
 DNS server
 WINS server
 NTP server
 LDAP server
 SMTP server
 File server
 FTP server
 Print server
 SharePoint server
 Domain controller
 Proxy server
 SNMP manager
ATTENTION
Depending on the server setting, there may be no response from a Ping test.