Fujitsu Ricoh Fujitsu N7100E Network Image Scanner - Manual (Page 109)

4.8 Checking the Network Status
109
4.8.2 Checking the Network Operating Status
The operating status of the network can be checked.
If the information is not shown, the network may not be operating normally. Refer to
"7.2
Network Connection Troubleshooting" (page 364) , and check the settings.
1. Select [Network Status] under [Check Network Status].
 The [Network Status] window shows the status of the currently operating network
connection.
Touch
Panel
HINT
 If connection to LDAP server is not possible, try the following steps:
1. Disconnect the LAN cable.
2. Press the [Shutdown] button on the touch panel to turn the scanner off.
3. Press the power button to start the scanner with the LAN cable disconnected.
4. Enter a non-duplicated IP address.
5. Re-connect the LAN cable to the scanner.
 If the DHCP server cannot be reached when DHCP is set to [On], "169.254.X.X" is displayed
for the IP address (X can be any number from 0 to 255).