Fujitsu Ricoh Fujitsu N7100E Network Image Scanner User Manual
Page 459
G.3 Configuring IPv6 Communication Environment
459
HINT
If the IP address is the same as one already in use, network communication problems will
occur. In this case, try the following steps:
1. Disconnect the LAN cable.
2. Press the [Shutdown] button on the touch panel to turn the scanner off.
3. Press the power button to start the scanner with the LAN cable disconnected.
4. Enter a non-duplicated IP address.
5. Re-connect the LAN cable to the scanner.
The connection with the scanner is lost if the IP address is changed via the Admin Tool. To
continue with other settings, close the Admin Tool and then access the scanner via the
Admin Tool again. If you access the scanner with an IP address, use the new IP address.
The information that is distributed when [Auto] is selected for the IPv6 address configuration
method, or when [Manual] is selected for the IPv6 configuration method and [On] is selected
for the RA reception is as follows:
DHCP
IP Address
DNS
DNS Suffix
RA
Subnet prefix length
Default Gateway