PLANET WGS3-24000 - Manual (Page 61)

61
。 Delete - Remove the selected session configuration.
4.2.6.4 Periodic Port Mirroring
Use this page to configure the periodic port mirroring.
Figure 4-2-30 Periodic Port Mirroring
Selection Criteria
。 Session ID - A session ID can be selected. By default the First Session is selected.
Configurable Data
。 Peroidic Port Mirroring Mode - Specifies the Periodic Port Mirroring Mode for a selected session ID. By default
Periodic Port Mirroring Mode is Disabled.
。 Interval Time - Specifies the periodic port mirroring time interval in seconds.Default value is 30. Valid Range is (30
to 300).
Non-Configurable Data
。 Source Port - Specifies the mirrored port. This field is only visible when periodic port mirroring mode is enabled.
Source port changes periodically as per specified Interval Time.
Command Buttons
。 Submit - Send the updated screen to the switch and cause the changes to take effect on the switch.