PLANET WGS3-24000 - Manual (Page 500)

500
no ip igmp query-interval
This command resets the query interval for the specified interface to the default value. This is the frequency at which IGMP
Host-Query packets are transmitted on this interface.
▫ Format no ip igmp query-interval
▫ Mode Interface Config
13.3.7 ip igmp query-max-response-time
This command configures the maximum response time interval for the specified interface, which is the maximum query
response time advertised in IGMPv2 queries on this interface.The time interval is specified in tenths of a second. The range for
is 0 to 255 tenths of a second.
▫ Default 100
▫ Format ip igmp query-max-response-time
▫ Mode Interface Config
no ip igmp query-max-response-time
This command resets the maximum response time interval for the specified interface, which is the maximum query response
time advertised in IGMPv2 queries on this interface to the default value. The maximum response time interval is reset to the
default time.
▫ Format no ip igmp query-max-response-time
▫ Mode Interface Config
13.3.8 ip igmp robustness
This command configures the robustness that allows tuning of the interface. The robustness is the tuning for the expected
packet loss on a subnet. If a subnet is expected to have a lot of loss, the Robustness variable may be increased for the interface.
The range for is 1 to 255.
▫ Default 2
▫ Format ip igmp robustness
▫ Mode nterface Config
no ip igmp robustness
This command sets the robustness value to default.
▫ Format no ip igmp robustness
▫ Mode Interface Config
13.3.9 ip igmp startup-query-count
This command sets the number of Queries sent out on startup, separated by the Startup Query Interval on the interface. The