PLANET WGS3-24000 - Manual (Page 448)

448
interface.
▫ Format show ip vrrp interface
▫ Modes Privileged EXEC
User EXEC
IP Address This field represents the configured IP Address for the Virtual router.
VMAC address Represents the VMAC address of the specified router.
Authentication type Represents the authentication type for the specific virtual router.
Priority Represents the priority value for the specific virtual router.
Advertisement interval Represents the advertisement interval for the specific virtual router.
Pre-Empt Mode Is the preemption mode configured on the specified virtual router.
Administrative Mode Represents the status (Enable or Disable) of the specific router.
State Represents the state (Master/backup) of the virtual router.
12.5.12 show ip vrrp interface brief
This command displays information about each virtual router configured on the switch. This command takes no options. It
displays information about each virtual router.
▫ Format show ip vrrp interface brief
▫ Modes Privileged EXEC
User EXEC
Interface Valid slot and port number separated by forward slashes.
VRID Represents the router ID of the virtual router.
IP Address The virtual router IP address.
Mode Represents whether the virtual router is enabled or disabled.
State Represents the state (Master/backup) of the virtual router
12.6 DHCP and BOOTP Relay Commands
This section describes the commands you use to configure BootP/DHCP Relay on the switch. A DHCP relay agent operates at
Layer 3 and forwards DHCP requests and replies between clients and servers when they are not on the same physical subnet.
12.6.1 bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
▫ Default disabled
▫ Format bootpdhcprelay cidoptmode