PLANET WGS3-24000 User Manual
Page 116
116
4.3.5.2 IGMP Snooping Interface Configuration
Figure 4-3-20
IGMP Snooping Interface Configuration
Configurable Data
。
Slot/Port
- The single select box lists all physical ,VLAN and LAG interfaces. Select the interface you want to
configure.
。
Admin Mode
- Select the interface mode for the selected interface for IGMP Snooping for the switch from the
pulldown menu.
The default is disable.
。
Group Membership Interval
- Specify the amount of time you want the switch to wait for a report for a particular
group on a particular interface before it deletes that interface from the group. Enter a value between 1 and 3600
seconds.
The default is 260 seconds.
。
Max Response Time
- Specify the amount of time you want the switch to wait after sending a query on an interface
because it did not receive a report for a particular group on that interface. Enter a value greater or equal to 1 and
less than the Group Membership Interval in seconds.
The default is 10 seconds. The configured value must be less than the Group Membership Interval.
。
Multicast Router Present Expiration Time
- Specify the amount of time you want the switch to wait to receive a
query on an interface before removing it from the list of interfaces with multicast routers attached. Enter a value
between 0 and 3600 seconds.
The default is 0 seconds. A value of zero indicates an infinite timeout, i.e. no expiration.
。
Fast Leave Admin mode
- Select the Fast Leave mode for the a particular interface from the pulldown menu.
The default is disable.
Command Buttons
。
Submit
- Update the switch with the values you entered. If you want the switch to retain the new values across a
power cycle you must perform a save. You will only see this button if you have Read/Write access privileges.