PLANET WGS3-24000 - Manual (Page 111)

111
LeaveAll PDU indicates that all registrations will shortly be deregistered. Participants will need to rejoin in order to
maintain registration. An instance of this timer exists for each GARP participant for each port. The Leave All Period
Timer is set to a random value in the range of LeaveAllTime to 1.5*LeaveAllTime. Permissible values are 200 to
6000 centiseconds (2 to 60 seconds). The factory default is 1000 centiseconds (10 seconds).
4.3.4.2 GARP Switch Configuration
This page is to Enable/Disable GVRP and GMRP mode. Note that it can take up to 10 seconds for GARP configuration changes
to take effect.
Figure 4-3-17 GARP Switch Configuration
。 GVRP Mode - Choose the GARP VLAN Registration Protocol administrative mode for the switch by selecting
enable or disable from the pull-down menu. The factory default is disabled.
。 GMRP Mode - Choose the GARP Multicast Registration Protocol administrative mode for the switch by selecting
enable or disable from the pull-down menu. The factory default is disabled.
4.3.4.3 GARP Port Configuration
Use this page to configure the GVRP/GMRP mode and GARP Timers on the ports. Note that it can take up to 10 seconds for
GARP configuration changes to take effect.
。 Slot.Port - Select the physical interface for which data is to be displayed or configured. It is possible to set the
parameters for all ports by selecting 'All'.
。 Port GVRP Mode - Choose the GARP VLAN Registration Protocol administrative mode for the port by selecting
enable or disable from the pull-down menu. If you select disable, the protocol will not be active and the Join Time,
Leave Time and Leave All Time will have no effect. The factory default is disabled.
。 Port GMRP Mode - Choose the GARP Multicast Registration Protocol administrative mode for the port by
selecting enable or disable from the pull-down menu. If you select disable, the protocol will not be active, and Join
Time, Leave Time and Leave All Time have no effect. The factory default is disabled.
。 Join Time (centiseconds) - Specify the time between the transmission of GARP PDUs registering (or
re-registering) membership for a VLAN or multicast group in centiseconds. Enter a number between 10 and 100
(0.1 to 1.0 seconds). The factory default is 20 centiseconds (0.2 seconds). An instance of this timer exists for each
GARP participant for each port.