PLANET WGS3-24000 - Manual (Page 361)

361
▫ Admin Mode - Selects the Port control administration state. The port must be enabled in order for it to be allowed into the
network. - May be enabled or disabled. The factory default is enabled.
▫ Physical Mode - Selects the desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex
mode and speed will be set from the auto-negotiation process. Note that the port's maximum capability (full duplex -100M)
will be advertised. Otherwise, this object will determine the port's duplex mode and transmission rate.
▫ The factory default is Auto.
▫ Physical Status - Indicates the port speed and duplex mode.
▫ Link Status - Indicates whether the Link is up or down.
▫ Link Trap - This object determines whether or not to send a trap when link status changes. The factory default is enabled.
▫ LACP Mode - Displays whether LACP is enabled or disabled on this port.
8.6.47 show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated Group.
▫ Format show port protocol { | all}
▫ Mode Privileged EXEC
▫ Group Name - This field displays the group name of an entry in the Protocol-based VLAN table.
▫ Group ID - This field displays the group identifier of the protocol group.
▫ Protocol(s) - This field indicates the type of protocol(s) for this group.
▫ VLAN - This field indicates the VLAN associated with this Protocol Group.
▫ Interface(s) - This field lists the slot/port interface(s) that are associated with this Protocol Group.
8.6.48 show port-channel
This command displays an overview of all port-channels (LAGs) on the switch.
▫ Format show port-channel { | all}
▫ Mode Privileged EXEC
▫ Logical slot/port - The logical slot and the logical port.
▫ Name - The name of this port-channel (LAG). You may enter any string of up to 15 alphanumeric characters.
▫ Link State - Indicates whether the Link is up or down.
▫ Admin Mode - May be enabled or disabled. The factory default is enabled.
▫ Link Trap Mode - This object determines whether or not to send a trap when link status changes. The factory default is
enabled.
▫ STP Mode - The Spanning Tree Protocol Administrative Mode associated with the port or portchannel (LAG). The
possible values are:
▫ Disable - Spanning tree is disabled for this port.
▫ Enable - Spanning tree is enabled for this port.
▫ Mbr Ports - A listing of the ports that are members of this port-channel (LAG), in slot/port notation. There can be a
maximum of eight ports assigned to a given port-channel (LAG).
▫ Port Speed - Speed of the port-channel port.