PLANET WGS3-24000 - Manual (Page 413)

413
10.1.29 show users authentication
This command displays all user and all authentication login information. It also displays the authentication login list assigned to
the default user.
▫ Format show users authentication
▫ Mode Privileged EXEC
▫ User - This field lists every user that has an authentication login list assigned.
▫ System Login - This field displays the authentication login list assigned to the user for system login.
▫ 802.1x Port Security - This field displays the authentication login list assigned to the user for 802.1x port security.
10.1.30 users defaultlogin
This command assigns the authentication login list to use for non-configured users when attempting to log in to the system. This
setting is overridden by the authentication login list assigned to a specific user if the user is configured locally. If this value is not
configured, users will be authenticated using local authentication only.
▫ Format users defaultlogin
▫ Mode Global Config
10.1.31 users login
This command assigns the specified authentication login list to the specified user for system login. The > must be a
configured and the must be a configured login list.
If the user is assigned a login list that requires remote authentication, all access to the interface from all CLI, web, and telnet
sessions will be blocked until the authentication is complete.
Note that the login list associated with the 'admin' user can not be changed to prevent accidental lockout from the switch.
▫ Format users login
▫ Mode Global Config
10.2 Secure Shell (SSH) Commands
The commands in this section is not supported currently
10.2.1 ip ssh
This command is used to enable SSH.
▫ Default Disabled
▫ Format ip ssh
▫ Mode Privileged EXEC
10.2.1.1 no ip ssh
This command is used to disable SSH.
▫ Format no ip ssh
▫ Mode Privileged EXEC