PLANET WGS3-24000 User Manual
Page 269
269
o
Submit
- Send the updated configuration to the router. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
4.7.1.3 Multicast Mroute Summary
This screen displays selected contents of the Mroute Table in tabular form. If there are no routes in the table you will not be
presented with the Selection Criteria.
Figure 4-6-51
Multicast Mroute Summary
Selection Criteria
o
Source IP
- Enter the IP address of the multicast packet source to be combined with the Group IP to fully identify a
single route whose Mroute table entry you want to display or clear. You may leave this field blank.
o
Group IP
- Enter the destination group IP address whose multicast route(s) you want to display or clear.
Non-Configurable Data
o
Incoming Interface
- The incoming interface on which multicast packets for this source/group arrive.
o
Outgoing Interface(s)
- The list of outgoing interfaces on which multicast packets for this source/group are
forwarded.
o
Up Time
- The time in seconds since the entry was created.
o
Expiry Time
- The time in seconds before this entry will age out and be removed from the table.
o
RPF Neighbor
- The IP address of the Reverse Path Forwarding neighbor.
o
Protocol
- The multicast routing protocol which created this entry. The possibilities are:
PIM-DM
PIM-SM
DVMRP
o
Flags
- The value displayed in this field is valid if the multicast routing protocol running is PIMSM. The possible
values are RPT or SPT. For other protocols an "------" is displayed.
Command Buttons