PLANET WGS3-24000 - Manual (Page 438)

438
User EXEC
Interface Valid slot and port number separated by forward slashes.
IP Address The IP address of the routing interface in 32-bit dotted decimal format.
IP Mask The IP mask of the routing interface in 32-bit dotted decimal format.
Netdir Bcast Indicates if IP forwards net-directed broadcasts on this interface.
Possible values are Enable or Disable.
MultiCast Fwd Indicates the multicast forwarding administrative mode on the interface.
Possible values are Enable or Disable.
12.2.23 show ip route
This command displays the routing table. The specifies the network for which the route is to be displayed and
displays the best matching best-route for the address. The specifies the subnet mask for the given . When
you use the longer-prefixes keyword, the and pair becomes the prefix, and the command displays the
routes to the addresses that match that prefix. Use the parameter to specify the protocol that installed the routes.
The value for can be connected, ospf, rip, static, or bgp. Use the all parameter to display all routes including best and
non-best routes. If you do not use the all parameter, the command only displays the best route.
"
Note : If you use the connected keyword for , the all option is not available because there are no best or
non-best connected routes.
▫ Format show ip route[{ [] | { [longer-prefixes] [] |
} [all] | all}]
▫ Mode Privileged EXEC
User EXEC
Route Codes Displays the key for the routing protocol codes that might appear in the routing table
output.
The show ip route command displays the routing tables in the following format:
Code IP-Address/Mask [Preference/Metric] via Next-Hop, Interface
The columns for the routing table display the following information:
Code The codes for the routing protocols that created the routes.
IP-Address/Mask The IP-Address and mask of the destination network corresponding to this route.
Preference The administrative distance associated with this route. Routes with low values are