PLANET WGS3-24000 - Manual (Page 421)

421
11.1.9 spanning-tree
This command sets the spanning-tree operational mode to enabled.
▫ Default Disabled
▫ Format spanning-tree
▫ Mode Global Config
11.1.9.1 no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the spanning-tree configuration is retained
and can be changed, but is not activated.
▫ Format no spanning-tree
▫ Mode Global Config
11.1.10 spanning-tree configuration name
This command sets the Configuration Identifier Name for use in identifying the configuration that this switch is currently using.
The is a string of at most 32 characters.
▫ Default The base MAC address displayed using hexadecimal notation as specified in IEEE 802 standard.
▫ Format spanning-tree configuration name
▫ Mode Global Config
11.1.10.1 no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
▫ Format no spanning-tree configuration name
▫ Mode Global Config
11.1.11 spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch is currently
using. The Configuration Identifier Revision Level is a number in the range of 0 to 65535.
▫ Default 0
▫ Format spanning-tree configuration revision <0-65535>
▫ Mode Global Config
11.1.11.1 no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch is currently
using to the default value, i.e. 0.
▫ Format no spanning-tree configuration revision
▫ Mode Global Config
11.1.12 spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal spanning tree. This will allow this port to
transition to Forwarding State without delay.