PLANET WGS3-24000 - Manual (Page 433)

433
▫ Format ip route [][]
▫ Mode Global Config
12.2.8 no ip route
This command deletes a single next hop to a destination static route. If you use the parameter, the next hop is
deleted. If you use the value, the preference value of the static route is reset to its default.
▫ Format no ip route [{ | }]
▫ Mode Global Config
12.2.9 ip route default
This command configures the default route. The value for is a valid IP address of the next hop router. The
is an integer value from 1 to 255. A route with a preference of 255 cannot be used to forward traffic.
▫ Default preference—1
▫ Format ip route default <nexthopip> [<preference>]
▫ Mode Global Config
12.2.10 no ip route default
This command deletes all configured default routes. If the optional parameter is designated, the specific next hop
is deleted from the configured default route and if the optional preference value is designated, the preference of the configured
default route is reset to its default.
▫ Format no ip route default [{ | }]
▫ Mode Global Config
12.2.11 ip route distance
This command sets the default distance (preference) for static routes. Lower route distance values are preferred when
determining the best route. The ip route and ip route default commands allow you to optionally set the distance (preference) of
an individual static route. The default distance is used when no distance is specified in these commands. Changing the default
distance does not update the distance of existing static routes, even if they were assigned the original default distance. The new
default distance will only be applied to static routes created after invoking the ip route distance command.
▫ Default 1