PLANET WGS3-24000 - Manual (Page 422)

422
▫ Format spanning-tree edgeport
▫ Mode Interface Config
11.1.12.1 no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal spanning tree.
▫ Format no spanning-tree edgeport
▫ Mode Interface Config
11.1.13 spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value. The Force Protocol Version can be one of the
following:
▫ 802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality supported)
▫ 802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality supported)
▫ 802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
▫ Default 802.1s
▫ Format spanning-tree forceversion <802.1d | 802.1w | 802.1s>
▫ Mode Global Config
11.1.13.1 no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value, i.e. 802.1s.
▫ Format no spanning-tree forceversion
▫ Mode Global Config
11.1.14 spanning-tree forward-time
This command sets the Bridge Forward Delay parameter to a new value for the common and internal spanning tree. The
forward-time value is in seconds within a range of 4 to 30, with the value being greater than or equal to "(Bridge Max Age / 2) +
1".
▫ Default 15
▫ Format spanning-tree forward-time <4-30>
▫ Mode Global Config
11.1.14.1 no spanning-tree forward-time
This command sets the Bridge Forward Delay parameter for the common and internal spanning tree to the default value, i.e. 15.
▫ Format no spanning-tree forward-time
▫ Mode Global Config
11.1.15 spanning-tree hello-time
This command sets the Hello Time parameter to a new value for the common and internal spanning tree. The hellotime
is in whole seconds within a range of 1 to 10 with the value being less than or equal to "(Bridge Max Age / 2) - 1".
▫ Default 2