PLANET WGS3-24000 - Manual (Page 58)

58
you want the port to participate in the network. The factory default is enabled.
。 LACP Mode - Selects the Link Aggregation Control Protocol administration state. The mode must be enabled in
order for the port to participate in Link Aggregation. May be enabled or disabled by selecting the corresponding
line on the pull-down entry field. The factory default is enabled.
。 Physical Mode - Use the pull-down menu to select the port's speed and duplex mode. If you select auto the
duplex mode and speed will be set by the auto-negotiation process. Note that the port's maximum capability (full
duplex and 100 Mbps) will be advertised. Otherwise, your selection will determine the port's duplex mode and
transmission rate. The factory default is auto. The selection when applied against the "All" option in Slot.Port is
applied to all applicable interfaces only.
。 Link Trap - This object determines whether or not to send a trap when link status changes. The factory default is
enabled.
。 Maximum Frame Size - The maximum Ethernet frame size the interface supports or is configured, including
Ethernet header, CRC, and payload. (1518 to 1600). The default maximum frame size is 1518.
Non-Configurable Data
。 Port Type - For normal ports this field will be blank. Otherwise the possible values are:
¾ Mon - the port is a monitoring port. Look at the Port Monitoring screens for more information.
¾ LAG - the port is a member of a Link Aggregation trunk. Look at the LAG screens for more information.
。 Physical Status - Indicates the port speed and duplex mode.
。 Link Status - Indicates whether the Link is up or down.
。 ifIndex - The ifIndex of the interface table entry associated with this port.
Figure 4-2-26 Port Configuration
4.2.6.2 Summary
This screen displays the status for all ports in the box.