PLANET WGS3-24000 - Manual (Page 467)

467
Redistribute into NSSA Shows whether to redistribute information into the NSSA
Default Information
Originate
Shows whether to advertise a default route into the NSSA
Default Metric Shows the metric value for the default route advertised into the NSSA.
Default Metric Type Shows the metric type for the default route advertised into the NSSA.
Translator Role Shows the NSSA translator role of the ABR, which is always or candidate.
Translator Stability
Interval
Shows the amount of time that an elected translator continues to perform its duties after it
determines that its translator status has been deposed by another router.
Translator State Shows whether the ABR translator state is disabled, always, or elected.
12.7.44 show ip ospf asbr
This command displays the internal OSPF routing table entries to Autonomous System Boundary Routers (ASBR). This
command takes no options.
▫ Format show ip ospf asbr
▫ Modes Privileged EXEC
▫ User EXEC
Type The type of the route to the destination. It can be either:
▫ intra — Intra-area route
▫ inter — Inter-area route
Router ID Router ID of the destination
Cost Cost of using this route
Area ID The area ID of the area from which this route is learned.
Next Hop Next hop toward the destination
Next Hop Intf The outgoing router interface to use when forwarding traffic to the next hop.
12.7.45 show ip ospf database
This command displays information about the link state database when OSPF is enabled. If you do not enter any parameters,
the command displays the LSA headers for all areas. Use the optional parameter to display database information
about a specific area. Use the optional parameters to specify the type of link state advertisements to display. Use asbrsummary