PLANET WGS3-24000 - Manual (Page 481)

481
▫ Mode Interface Config
no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s) to be
received.
▫ Format no ip rip receive version
▫ Mode Interface Config
12.8.11 ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be sent.
The value for is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP version 1 compatibility mode)
which sends RIP version 2 formatted packets via broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow
any RIP control packets to be sent.
▫ Default rip2
▫ Format ip rip send version {rip1 | rip1c | rip2 | none}
▫ Mode Interface Config
no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be sent.
▫ Format no ip rip send version
▫ Mode Interface Config
12.8.12 hostroutesaccept
This command enables the RIP hostroutesaccept mode.
▫ Default enabled
▫ Format hostroutesaccept
▫ Mode Router RIP Config
no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
▫ Format no hostroutesaccept
▫ Mode Router RIP Config
12.8.13 split-horizon
This command sets the RIP split horizon mode. Split horizon is a technique for avoiding problems caused by including routes in
updates sent to the router from which the route was originally learned. The options are: None - no special processing for this