PLANET WGS3-24000 - Manual (Page 353)

353
VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert
registration for the same attribute in order to maintain uninterrupted service time is 20 to 600 (centiseconds).
"
Note : This command has an effect only when GVRP is enabled.
▫ Default 60 centiseconds (0.6 seconds)
▫ Format set garp timer leave all <20-600>
▫ Mode Global Config
8.6.25.1 no set garp timer leave all
This command sets the GVRP leave time for all ports to the default 60 centiseconds (0.6 seconds).
"
Note : This command has an effect only when GVRP is enabled.
▫ Format no set garp timer leave all
▫ Mode Global Config
8.6.26 set garp timer leaveall
This command sets how frequently Leave All PDUs are generated per port. A Leave All PDU indicates that all registrations will
be unregistered. Participants would need to rejoin in order to maintain registration. The value applies per port and per GARP
participation. The time may range from 200 to 6000 (centiseconds).
"
Note : This command has an effect only when GVRP is enabled.
▫ Default 1000 centiseconds (10 seconds)
▫ Format set garp timer leaveall <200-6000>
▫ ModeInterface Config
8.6.26.1 no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated per port to 1000 centiseconds (10 seconds).
"
Note : This command has an effect only when GVRP is enabled.
▫ Format no set garp timer leaveall
▫ Mode Interface Config
8.6.27 set garp timer leaveall all
This command sets how frequently Leave All PDUs are generated for all ports. A Leave All PDU indicates that all registrations
will be unregistered. Participants would need to rejoin in order to maintain registration. The value applies per port and per GARP
participation. The time may range from 200 to 6000 (centiseconds).
"
Note : This command has an effect only when GVRP is enabled.