PLANET WGS3-24000 - Manual (Page 53)

53
44.2.5.3 Command Logger Configuration
This page includes the following fields:
Configurable Data
。 Admin Mode - Enable/Disable the operation of the CLI Command logging by selecting the corresponding pulldown
field and clicking Submit.
Figure 4-2-19 Command Logger Configuration
4.2.5.4 Console Log Configuration
This allows logging to any serial device attached to the host.
Configurable Data
。 Admin Status -A log that is "Disabled" shall not log messages. A log that is "Enabled" shall log messages. Enable
or Disable logging by selecting the corresponding line on the pulldown entry field.
。 Severity Filter - A log records messages equal to or above a configured severity threshold. Select the severity
option by selecting the corresponding line on the pulldown entry field. These severity levels have been enumerated
below:
- Emergency (0) : system is unusable
- Alert (1) : action must be taken immediately
- Critical (2) : critical conditions
- Error (3) : error conditions
- Warning (4) : warning conditions
- Notice(5) : normal but significant conditions
- Informational(6) : informational messages
- Debug(7) : debug-level messages
Figure 4-2-20 Console Log Configuration