PLANET WGS3-24000 - Manual (Page 513)

513
▫ Mode Global Config
13.5.9 ip pim-trapflags
This command enables the PIM trap mode for both Sparse Mode (SM) and Dense Mode. (DM). Default disabled
▫ Format ip pim-trapflags
▫ Mode Global Config
no ip pim-trapflags
This command disables the PIM trap mode.
▫ Format no ip pim-trapflags
▫ Mode Global Config
13.5.10 ip pimsm staticrp
This command is used to create RP IP address for the PIM-SM router. The parameter is the IP address of the RP.
The parameter is the group address supported by the RP. The parameter is the group mask for
the group address.
▫ Default disabled
▫ Format ip pimsm staticrp
▫ Mode Global Config
no ip pimsm staticrp
This command is used to delete RP IP address for the PIM-SM router. The parameter is the IP address of the RP.
The parameter is the group address supported by the RP. The parameter is the group mask for
the group address.
▫ Format no ip pimsm staticrp
▫ Mode Global Config
13.5.11 ip pimsm register-rate-limit
This command the register threshold rate for PIM-SM..
▫ Default disabled
▫ Format ip pimsm register-rate-limit <0-2000>
▫ Mode Global Config