PLANET WGS3-24000 - Manual (Page 461)

461
no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
▫ Format no ip ospf dead-interval
▫ Mode Interface Config
12.7.31 ip ospf hello-interval
This command sets the OSPF hello interval for the specified interface. The value for seconds is a valid positive integer, which
represents the length of time in seconds. The value for the length of time must be the same for all routers attached to a network.
Valid values range from 1 to 65535.
▫ Default 10
▫ Format ip ospf hello-interval
▫ Mode Interface Config
no ip ospf hello-interval
This command sets the default OSPF hello interval for the specified interface.
▫ Format no ip ospf hello-interval
▫ Mode Interface Config
12.7.32 ip ospf priority
This command sets the OSPF priority for the specified router interface. The priority of the interface is a priority integer from 0 to
255. A value of 0 indicates that the router is not eligible to become the designated router on this network.
▫ Default 1, which is the highest router priority.
▫ Format ip ospf priority <0-255>
▫ Mode Interface Config
no ip ospf priority
This command sets the default OSPF priority for the specified router interface.
▫ Format no ip ospf priority
▫ Mode Interface Config
12.7.33 ip ospf retransmit-interval
This command sets the OSPF retransmit Interval for the specified interface. The retransmit interval is specified in seconds. The
value for is the number of seconds between link-state advertisement retransmissions for adjacencies belonging to
this router interface. This value is also used when retransmitting database description and link-state request packets. Valid
values range from 0 to 3600 (1 hour).
▫ Default 5
▫ Format ip ospf retransmit-interval <0-3600>