PLANET WGS3-24000 - Manual (Page 232)

232
4.6.4.7 OSPF Neighbor Table
This screen displays the OSPF neighbor table list. When a particular neighbor ID is specified, detailed information about a
neighbor is given. The information below will only be displayed if OSPF is enabled.
Figure 4-6-24 OSPF Neighbor Table
Selection Criteria
。 Slot/Port - Selects the interface for which data is to be displayed or configured. Slot 0 is the base unit.
Non-Configurable Data
。 Router ID - A 32 bit integer in dotted decimal format representing the neighbor interface.
。 IP Address - The IP address of the neighboring router's interface to the attached network. It is used as the
destination IP address when protocol packets are sent as unicasts along this adjacency. Also used in router-LSAs
as the Link ID for the attached network if the neighboring router is selected to be designated router. The Neighbor IP
address is learned when Hello packets are received from the neighbor. For virtual links, the Neighbor IP address is
learned during the routing table build process.
。 Neighbor Interface Index - A Slot/Port identifying the neighbor interface index.
Command Buttons
。 Refresh - Refresh the data on the screen with the present state of the data in the switch.