PLANET WGS3-24000 - Manual (Page 170)

170
4.5 QoS
4.5.1 IP Access Control List
An ACL consists of a set of rules which are matched sequentially against a packet. When a packet meets the match criteria of a
rule, the specified rule action (Permit/Deny) is taken and the additional rules are not checked for a match. On this menu the
interfaces to which an ACL applies must be specified, as well as whether it applies to inbound or outbound traffic. Rules for the
ACL are specified/created using the ACL Rule Configuration menu.
4.5.1.1 IP ACL Configuration
This page is to configure the access control list on ports.
Figure 4-5-1 IP ACL Configuration
Configurable Data
。 ACL - Make a selection from the pull-down menu. A new Access Control List may be created or the configuration
of an existing ACL can be updated.
。 ACL ID - ACL ID must be a whole number in the range of 1 to 99 for IP Standard Access Lists and 100-199 for IP
Extended Access Lists.
。 Slot.Port(s) - This dynamic multi-selector lists all available valid interfaces for ACL mapping. All non-routing
physical interfaces and interfaces participating in LAGs that are not already assigned to an ACL are listed. An
interface can be mapped to one and only one ACL, but multiple interfaces can be assigned to one ACL.
。 Direction - Select the packet filtering direction for the ACL from the pulldown menu.
Choices:
¾ Inbound
The packet direction for a given ACL is the same for all affected interfaces.
Non-Configurable Data
。 Table - Displays the current and maximum number of ACLs.