PLANET WGS3-24000 - Manual (Page 486)

486
▫ Mode Global Config
13.1.3 ip multicast staticroute
This command creates a static route which is used to perform RPF checking in multicast packet forwarding. The combination of
the and the fields specify the network IP address of the multicast packet source. The is
the IP address of the next hop toward the source. The is the cost of the route entry for comparison with other routes to
the source network and is a value in the range of 0 and 255. The current incoming interface is used for RPF checking for
multicast packets matching this multicast static route entry.
▫ Default none
▫ Format ip multicast staticroute
▫ Mode Global Config
no ip multicast staticroute
This command deletes a static route in the static mcast table. The is the IP address of the multicast packet
source.
▫ Format no ip multicast staticroute
▫ Mode Global Config
13.1.4 ip multicast ttl-threshold
This command applies the given to a routing interface. The is the TTL threshold which is to be
applied to the multicast Data packets which are to be forwarded from the interface. The value for has range from 0
to 255.
▫ Default 1
▫ Format ip multicast ttl-threshold
▫ Mode Interface Config
no ip multicast ttl-threshold
This command applies the default to a routing interface. The is the TTL threshold which is to be
applied to the multicast Data packets which are to be forwarded from the interface.
▫ Format no ip multicast ttl-threshold
▫ Mode Interface Config
13.1.5 mrinfo
This command is used to query the neighbor information of a multicast-capable router specified by [ipaddr]. The default value is
the IP address of the system at which the command is issued. The mrinfo command can take up to 2 minutes to complete. Only
one mrinfo command may be in process at a time. The results of this command will be available in the results buffer pool which
can be displayed by using "show mrinfo".