PLANET WGS3-24000 - Manual (Page 343)

343
This command disables Link Up/Down traps for the entire switch.
▫ Format no snmp-server enable traps linkmode
▫ Mode Global Config
8.5.29 snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is sent when a user logs in to the
terminal interface (EIA 232 or telnet) and there is an existing terminal interface session.
▫ Default Enabled
▫ Format snmp-server enable traps multiusers
▫ Mode Global Config
8.5.29.1 no snmp-server enable traps multiusers
This command disables Multiple User traps.
▫ Format no snmp-server enable traps multiusers
▫ Mode Global Config
8.5.30 snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification traps.
▫ Default Enabled
▫ Format snmp-server enable traps stpmode
▫ Mode Global Config
8.5.30.1 no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps.
▫ Format no snmp-server enable traps stpmode
▫ Mode Global Config
8.5.31 snmptrap
This command adds an SNMP trap name. The maximum length of name is 16 case-sensitive alphanumeric characters.
▫ Default The default name for the six undefined community names is Delete.
▫ Format snmptrap
▫ Mode Global Config
8.5.31.1 no snmptrap
This command deletes trap receivers for a community.
▫ Format no snmptrap
▫ Mode Global Config