PLANET WGS3-24000 - Manual (Page 344)

344
8.5.32 snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of name is 16 case-sensitive
alphanumeric characters.
▫ Format snmptrap ipaddr
▫ Mode Global Config
#
Note :
IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries using the
same IP address, the first entry is retained and processed. All duplicate entries are ignored.
8.5.33 snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive traps). Disabled trap
receivers are inactive (not able to receive traps).
▫ Format snmptrap mode
▫ Mode Global Config
8.5.33.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able to receive traps).
▫ Format no snmptrap mode
▫ Mode Global Config
8.5.34 telnet
This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be established until there are no
more sessions available. If sessions are disabled, no new telnet sessions are established. An established session remains
active until the session is ended or an abnormal network error ends it.
▫ Default Enabled
▫ Format telnet
▫ Mode Privileged EXEC
8.5.34.1 no telnet
This command disables telnet sessions. If sessions are disabled, no new telnet sessions are established.
▫ Format no telnet
▫ Mode Privileged EXEC