PLANET WGS3-24000 User Manual
Page 155
155
Figure 4-4-8
RADIUS Configuration
4.4.2.2 RADIUS Server Configuration
This page is to configure the RADIUS server connection features.
。
RADIUS Server IP Address -
Selects the RADIUS server to be configured. Select add to add a server.
。
IP Address -
The IP address of the server being added.
。
Port -
The UDP port used by this server. The valid range is 0 - 65535.
。
Secret -
The shared secret for this server. This is an input field only.
。
Apply -
The Secret will only be applied if this box is checked. If the box is not checked, anything entered in the
Secret field will have no affect and will not be retained. This field is only displayed if the user has READWRITE
access.
。
Primary Server -
Sets the selected server to thePrimary or Secondary server.
。
Message Authenticator -
Enable or disable the message authenticator attribute for the selected server.
。
Current -
Indicates if this server is currently in use as the authentication server.
。
Secret Configured -
Indicates if the shared secret for this server has been configured.
Command Buttons
。
Submit -
Send the updated screen to the switch and cause the changes to take effect on the switch but these
changes will not be retained across a power cycle unless a save is performed.
。
Remove -
Remove the selected server from the configuration. This button is only available to READWRITE users.
These changes will not be retained across a power cycle unless a save is performed.
。
Refresh -
Update the information on the page.