PLANET WGS3-24000 User Manual
Page 192
192
。
IP DSCP Traffic Class
- Specify which internal traffic class to map the corresponding IP DSCP value. Valid Range is
(0 to 7) .
Non-Configurable Data
。
Untrusted Traffic Class
- Displays traffic class (i.e. queue) to which all traffic is directed when in 'untrusted' mode.
Valid Range is (0 to 7).
。
Non-IP Traffic Class
- Displays traffic class (i.e. queue) to which all non-IP traffic is directed when in 'trust
ip-precedence' or 'trust ip-dscp' mode. Valid Range is (0 to 7).
。
802.1p Priority
- Displays the 802.1p priority to be mapped.
。
IP Precedence Value
- Displays IP Precedence value. Valid Range is (0 to 7).
。
IP DSCP Value
- Displays IP DSCP value. Valid Range is (0 to 63).
Command Buttons
。
Submit
- Send the updated configuration to the switch. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
。
Restore Defaults
- Restores default settings.
4.5.5.2 IP Precedence Mapping Configuration
This page is to configure the IP Precedence mapping on the port.
Figure 4-5-27
IP Precedence Mapping Configuation
。
Slot.Port -
Select the physical interface for which you want to display or configure data. Select 'All' to set the
parameters for all ports to the same values.