PLANET WGS3-24000 User Manual
Page 167
167
4.4.3.2 Server Configuration
This page is to configure the TACACS+ Serve, include IP Address, port and and Key String.
Figure 4-4-18
TACACS+ Server Configuration
Selection Criteria
。
TACACS+ Server
Selects the TACACS+ server for which data is to be displayed or configured. If the add item is
selected, a new TACACS server can be configured.
Configurable Data
。
IP Address
- Specifies the TACACS+ Server IP address.
。
Priority
- Specifies the order in which the TACACS+ servers are used. It should be within the range 0-65535.
。
Port
- Specifies the authentication port. It should be within the range 0-65535.
。
Key String
- Specifies the authentication and encryption key for TACACS+ communications between the device and
the TACACS+ server. The valid range is 0-128 characters.
The key must match the encryption used on the
TACACS+ server.
。
Connection Timeout
- The amount of time that passes before the connection between the device and the TACACS+
server time out. The range is between 1-30.
Command Buttons
。
Submit
- Send the updated screen to the switch and cause the changes to take effect on the switch but these
changes will not be retained across a power cycle unless a save is performed.
。
Remove
- Remove the selected server from the configuration.