PLANET WGS3-24000 - Manual (Page 250)

250
4.6.6 ARP
Use the following screen to display or edit entries in the Static ARP Table. Entries added to this table are retained
until the associated IP interface is deleted or the switch is reset to the factory defaults.
4.6.6.1 ARP Create
Use this screen to add an entry to the Address Resolution Protocol table.
Figure 4-6-36 ARP Create
Configurable Data
。 IP Address - Enter the IP address you want to add. It must be the IP address of a device on a subnet attached to
one of the switch's existing routing interfaces.
。 MAC Address - The unicast MAC address of the device. Enter the address as six two-digit hexadecimal numbers
separated by colons, for example 00:06:29:32:81:40.
4.6.6.2 ARP Table Configuration
You can use this screen to change the configuration parameters for the Address Resolution Protocol Table. You can also use
this screen to display the contents of the table.