TA Triumph-Adler DC 2020 User Manual
Page 99
4-17
Section 4 Other Features of this Fax
3. Use the cursor down key to select “Program Subad relay box”
[Subad. relay register”]. Then press the Enter key.
4. Scroll through the menu with the cursor up or the cursor down key
and select an unregistered box.
5. Press the Enter key.
6. Enter the subaddress that you want to use for this F-Code Based
Relay Box.
* Each subaddress is a 4-digit number from “0000” to “9999”.
* If you want to reset the displayed number to “0000”, simply press
the Stop/Clear key.
7. Press the Enter key.
8. Enter the F-Code password that you want to use for this F-Code
Based Relay Box.
* The password can be up to 4 digits in length and can include any
combination of the numerals 0 - 9 and the symbols “
” and “#”.
* If you receive an F-Code Based Relay Broadcast transmission
where your fax will act as the relay station and you have
registered “0000” as the F-Code password for the corresponding
F-Code Based Relay Box, a check of the passwords will not be
performed.
* If you want to reset the displayed number to “0000”, simply press
the Stop/Clear key.
9. Press the Enter key.
10. Repeat step
1
and
2
below until all of the final destination fax
numbers are registered. (Max. 132 destinations)
1
Enter the fax number of a final destination.
* You can use the keypad, abbreviated numbers, one-touch
keys and group dial keys to enter the fax number. Chain dial
keys can be used as well.
2
Press the Enter key.
11. Press the Enter key.
12. Use the cursor up or the cursor down key to select whether or
not you want the documents to be printed out at the relay station.
* If you want the documents to be printed out, select “On”.
13. Press the Enter key.
14. If you want to have a Transmission Report sent from the relay
station, enter the fax number of the location that you would like
that report to be sent to.
If you do NOT want to have this report sent to anyone, this step
is not necessary. Proceed to step 15.
* You can use the keypad, abbreviated numbers and one-touch
keys to enter the fax number. Chain dial keys can be used as
well.
15. Press the Enter key. Registration of that F-Code Based Relay
Box is complete.
> If you want to continue registering other F-Code Based Relay
Boxes, return to step 4.
> If you are finished registering F-Code Based Relay Boxes,
press the Reset key. The operation panel will return to the
initial mode settings.
Program Subad relay box:
End
➪
#01 1234
#02 2345
Subad. relay register:
End
➪
#01 1234
#02 2345
Program Subad relay box:
#01 1234
#02 2345
➪
#03
Subad. relay register:
#01 1234
#02 2345
➪
#03
SubAddress:0000
Enter SubAddress.
Subaddress:0000
Enter subaddress numbers
SubAddress:3456
Enter SubAddress.
Subaddress:3456
Enter subaddress numbers
Password:0000
Enter Your Password
Password:0333
Enter Your Password
v :
Enter Destination Station
v :0765432
Enter Destination Station
Print Here:
On
➪
Off
Print Here:
➪
On
Off
v :
Enter Report Destination
v :023456
Enter Report Destination
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)