TA Triumph-Adler DC 2020 - Manual (Page 146)

6-6
Setting the Number of Rings
(FAX/TEL Switching)[Inch version only]
When a separately purchased telephone is connected to this fax
machine and Auto FAX/TEL Switching is turned ON, the number of
times the fax will let the telephone ring before the Auto FAX/TEL
Switching mode engages can be set here to any number between
0 - 15. After the number of rings designated here, if the call is from a
facsimile this fax will switch to fax reception. If other party is on the
line, the telephone will begin to ring again.
(Refer to “Auto FAX/TEL Switching”, page 4-2.)
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise the cover plate and press the Configure key.
2. Use the cursor up or the cursor down key to select “#Rings(AutoRX)”.
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select the number of
times the fax will let the telephone ring.
* The asterisk (*) in the message display indicates the current
setting.
* If you select “0 Times”, the Auto FAX/TEL Switching mode will
engage as soon as a call comes in.
5. Press the Enter key. The setting for the number of rings in the
Auto FAX/TEL Switching mode is complete.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Section 6 Various Settings and Registration in this Fax
# of Rings (Auto Switch):
➪
0Times
1Times
*2Times
Set Fax:
# of Rings : 2Times
#Rings(TAD) :10Times
➪ #Rings(AutoRX): 2Times
Set Fax:
# of Rings : 2Times
#Rings(TAD) :10Times
➪
#Rings(AutoRX): 3Times
JUL-08-2001 12:00
Set Document
Set Fax:
End
➪
Line Type :Tone Dial
TTI :Outside P.
# of Rings (Auto Switch):
1Times
* 2Times
➪ 3Times