TA Triumph-Adler DC 2020 - Manual (Page 73)

2-19
Section 2 Various Functions of this Fax
Manual Fax Transmission
Once you are connected with the destination party, transmission
can be initiated manually by pressing the Start key.
Use this mode when you want to talk to the other party prior to
actual transmission of the documents, or when the other party
must manually switch to fax reception. * Manual Fax Transmission is only possible if a separately
purchased telephone is connected to this fax machine.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Set the documents you want to transmit.
JUL-08-2001 12:00
Set Document
2. Pick up the telephone receiver or press the On-Hook key.
JUL-08-2001 12:00
Document:8 1 / 2 x11
Enter Destination
* If you press the On-Hook key, the On-Hook indicator will light.
08-JUL-2001 12:00
Set original
(Inch)
(Metric)
08-JUL-2001 12:00
Document :A4
Enter destination
(Inch)
(Metric)
(Inch) (Metric)
3. Dial the destination fax number.
4. Check whether or not you are connected to a fax machine.
> If you hear a fax tone…
You are connected to a fax machine.
Press the Start key. Fax transmission will begin.
> If the other party answers…
You are connected to a telephone.
Press the Start key at the end of the conversation to initiate
transmission. Fax transmission will begin.
v :36852
Document:8 1 / 2 x11
Enter Destination
v :36852
Document :A4
Enter destination
(Inch)
(Metric)
(Inch) (Metric)
5. Hang up the receiver when “Communicating” appears in the
message display.