TA Triumph-Adler DC 2020 - Manual (Page 160)

7-2
Section 7 Optional Equipment
Duplex Unit
By installing the optional Duplex Unit, Duplex Reception – in which
paper is turned over inside the fax machine and printing
accomplished on the back side – will be possible.
When the width of each page received is exactly the same, the
documents will be printed onto the front and back sides of that size
of paper.
* To use the Duplex Reception function, it is necessary to turn it ON
in advance.
* When the Duplex Reception function is turned ON, all pages of a
fax reception will be temporarily stored in memory – regardless of
the reception mode setting – and they will then be printed out at
one time.
● Turning Duplex Reception ON/OFF
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise the cover plate and press the Configure key.
2. Use the cursor up or the cursor down key to select “Duplex RX”
[“2-sided RX”].
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select whether to turn
Duplex Reception ON or OFF.
* The asterisk (*) in the message display indicates the current
setting.
5. Press the Enter key. The setting for Duplex Reception is complete.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Adding Additional Memory
By adding additional memory in the fax machine, 4 MB of the
resulting total of 8 MB can be used for bitmapping and you will then
be able to transmit and receive documents using the Ultra Fine
resolution mode. In this case, the remaining 4 MB will be used for
imaging and will allow you to store more documents into memory (for
transmission or through reception).
To select the Ultra Fine resolution mode, press the resolution select
key to light the Ultra Fine indicator.
* Refer to the Instruction Handbook for your copier
for information on other optional equipment.
Set Fax:
End
➪
Line Type :Tone Dial
TTI :Outside P.
Set Fax:
PaperFeed Sel.:AutoSelect
2 in 1 RX :Off
➪ Duplex RX :Off
Duplex RX:
➪
On
*Off
Set Fax:
PaperFeed Sel.:AutoSelect
2 in 1 RX :Off
➪
Duplex RX :On
Set fax:
Paper feed sel:Auto sel.
2-up RX :Off
➪
2-sided RX :Off
2-sided RX:
➪
On
*Off
Set fax:
Paper feed sel:Auto sel.
2-up RX :Off
➪ 2-sided RX :On
(Inch)
(Metric)
(Inch)
(Metric)
(Inch) (Metric)
(Inch)
(Metric)
(Inch)
(Metric)
Set fax:
End
➪
TTI :Outside p.
Print report P P