TA Triumph-Adler DC 2020 - Manual (Page 169)

Section 8 Reference Information
8-9
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION
Busy
The line is busy or the other party does not answer after automatically redialing the set number of times.
Perform transmission or reception procedures again.
Stopped Transmission has been interrupted by pressing the Stop/Clear key.
Stopped Reception has been interrupted by pressing the Stop/Clear key.
U00300 The destination fax has run out of recording paper. Check with the destination party.
U00420 -
U00462 Connection was made on a call initiated by the transmitting party, but the transmission has been interrupted because the
transmitting party does not possess the necessary communication capabilities.
Stopped
During multiple communication (Broadcast transmission, Polling reception, etc.), this unit was unable to transmit to all
destinations due to a communications interruption.
U00600 -
U00690
Communication was interrupted due to trouble with your unit. Perform transmission or reception procedures again.
U00700 Communication was interrupted due to trouble with the other party’s fax unit. Check with the other party.
U00800
U00810
Unsuccessfully transmitted page(s) remain. Perform transmission procedures again.
U00900
U00910
Unsuccessfully received page(s) remain. Perform reception procedures again.
U01000 -
U01092
A communication error occurred during transmission. Perform transmission procedures again.
Error Code Tables
When a communications error occurs, one of the following error codes will be printed out on the
corresponding Transmission Report or Reception report as well as the Activity report.
Refer to the following tables for a more detailed explanation of the error.
U01100 -
U01199
A communication error occurred during reception. Perform reception procedures again.
U01400
A communication which uses the timer was scheduled, and a number was entered using an abbreviated number or
one-touch key, etc., but communication with that party was impossible because that number was no longer registered when
the scheduled time arrived. Check your unit.
U01500 A communication error occurred during transmission at high transmission speed. Perform transmission procedures again.
U01600
A communication error occurred during reception at high transmission speed. Perform reception procedures again after
having the transmitting party lower the transmission speed.
U01700
U01720
A communication error occurred during transmission at high transmission speed. Perform transmission procedures again.
* If an error occurs during communication at a transmission speed of 33600 bps, the “U” in the error codes noted below will change to an “E”.