TA Triumph-Adler DC 2020 - Manual (Page 78)

3-4
Section 3 Troubleshooting
Message Procedure Page
“Communication Error.”
An error has occurred during a fax transmission or fax reception.
Check the error code – that indicates the origin of the error – on the corresponding
Transmission Report (or Reception Report) that is printed out after the error.
8-9
“Continue TX”
[“Continue transmission”]
This message will appear in response to pressing the Stop/Clear key while the
Alternate Display key is held down during a communication to multiple destinations,
such as Broadcast Transmission or Polling Reception.
• Use the cursor up or the cursor down key to select “Yes” if you want to continue the
current operation. However, the individual communication in progress at the time the
Stop/Clear key was pressed will be canceled.
• Use the cursor up or the cursor down key to select “No” if you want to cancel the
communication to all remaining destinations.
___
“Call for Service”
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service center or the place of purchase.
If “C” and a 3-digit number are displayed as well, inform the service personnel of the
displayed number.
___
“Time for maintenance.”
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service center or the place of purchase. ___
“Misfeed in feeder.
Remove original(s).” ___
1-26
4-13
4-46
A document has jammed in the DF. Refer to the included Instruction Handbook for
your DF or copier and remove the jammed document.
Then, reset all of the documents in the DF. The fax will recount the number of
documents that were already scanned and will start the scanning operation once again
from the document that jammed.
The memory has reached its capacity while scanning in documents. Press the Enter
key and then select “Yes” if you want to transmit those documents that have already
been completely scanned. If you want to completely cancel the transmission, use the
cursor up or the cursor down key to select “No” and then press the Enter key.
* If you do not press the Enter key within a certain amount of time, the Auto Clear
function will engage and all corresponding data will be erased from memory.
* In order to transmit all of the documents after you have completely canceled the
operation, try transmission procedure again after memory becomes available or after
you create available space in memory.
“Memory Full”
You attempted to use the DF to transmit a document that was over 63" [1600 mm] in
length. Press the Enter key to eject the documents remaining in the DF. The operation
panel will return to the initial mode settings.
“Original is too long.”
[“Original sheet is too long”]
1-22