TA Triumph-Adler DC 2020 - Manual (Page 142)

* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise the cover plate and press the Configure key.
6-2
Turning Report Print Out ON/OFF
Five different reports can be printed out for checking such points as
whether a transmission or reception was accomplished correctly or
not. You can also have each of these reports printed out
automatically or turn OFF automatic print out of each report.
2. Use the cursor up or the cursor down key to select “Print Report”.
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select which report to set.
* The following example is for setting the Delayed Communication
Report.
5. Press the Enter key.
6. Use the cursor up or the cursor down key to select whether or not
you want that report to be automatically printed out.
* The asterisk (*) in the message display indicates the current
setting.
* If you want the report to be printed out automatically, select “On”.
* If you selected “TX Transaction” or “RX Transaction” in step 4, it
will also be possible to select “Output only be Condition” here. In
this case, the corresponding report will only be printed out under
those conditions that are explained under the information for that
report as shown on the left side of this page.
7. Press the Enter key. The setting for that report is complete.
> If you want to continue the setting procedure for other reports,
repeat steps 4 - 7.
> If you want to perform other setting procedures, select “End” and
then press the Enter key.
> If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Section 6 Various Settings and Registration in this Fax
Print Report:
TX Transaction:On
RX Transaction:Off
➪
Delayed Comm. :On
Delayed Comm. Report:
➪
*On
Off
Delayed Comm. Report:
*On
➪ Off
Print Report:
TX Transaction:On
RX Transaction:Off
➪
Delayed Comm. :Off
Print Report:
End
➪
ActivityCont'l:On
Management :On
Set Fax:
Line Type :Tone Dial
TTI :Outside P.
➪
Print Report P P
Set this report to be printed out upon reaching a predetermined
number of communications in order to check the details of those
communications.
Set this report to be printed out in order to check the details,
listed by department, of all communications occurring under
Restricted Access.
Set this report to be printed out after each transmission to check
whether the
* It is also possible to set this report to be printed out only under
certain conditions (a communication error, a Broadcast
Transmission, a transmission that uses the timer and an
Encryption Transmission).
Set this report to be printed out after each reception to check
whether the reception was accomploshed correctly or not.
* It is also possible to set this report to be printed out only under
certain conditions (a communication error, a Polling Reception,
an Encryption Reception and an F-Code Based Confidential
Reception).
Set this report to be printed out after each communication that
uses the timer is scheduled to check the information related to
that communication.
JUL-08-2001 12:00
Set Document
Set Fax:
End
➪ Line Type :Tone Dial
TTI :Outside P.
08-JUL-2001 12:00
Set original
Print report:
End
➪ Activity contr:On
Management :On
(Inch)
(Metric)
(Inch) (Metric)
(Inch)
(Metric)
Set fax:
End
➪ TTI :Outside p.
Print report P P
Set fax:
End
TTI :Outside p.
➪
Print report P P
(Inch)
(Metric)
(Inch)
(Metric)