TA Triumph-Adler DC 2020 - Manual (Page 28)

1-20
Section 1 Basic Use of this Fax
Sending Documents
The following contains explanations on the standard method for transmitting
documents. Carefully read all the notes regarding acceptable documents, etc.,
to ensure correct operation.
1
Switching to the Fax Operation mode
Press the COPY/FAX switching key to switch to the Fax
Operation mode.
* When the FAX indicator is lit, the machine is in the Fax
Operation mode.
* Check the message display to make sure that the operation panel
is in the initial mode for fax operation. If the operation panel is not
in the initial mode, press the Reset key.
2
Selecting the transmission mode
Select the desired transmission mode.
* There are two transmission modes available in this fax:
Memory Transmission and Direct Feed Transmission.
Memory Transmission is the default setting in this fax and,
in this case, the Memory Tx. indicator will be lit.
* To switch between the Memory Transmission and Direct Feed
Transmission modes, press the Memory Tx. key.
* If the Memory Tx. indicator is NOT lit, the fax is in the Direct
Feed Transmission mode.
JUL-08-2001 12:00
Set Document
08-JUL-2001 12:00
Set original
(Inch)
(Metric)
* It is also possible to select which transmission mode will be the
default setting for the initial mode. Refer to “Setting the Default
Transmission Mode”, page 6-15.
(Inch) (Metric)
(Inch) (Metric)
(Inch) (Metric)
(Inch) (Metric)