TA Triumph-Adler DC 2020 - Manual (Page 154)

6-14
Turning Remote Diagnosis ON/OFF
Especially if trouble occurs in this fax in which it is necessary to call
for service, it is possible for our service center computer to access
the fax directly over the telephone line and check its status and other
information about the trouble.
* To use Remote Diagnosis, it is necessary to enter into a contract
with an authorized service center in advance and also to register a
predetermined Remote Test ID in advance.
(Refer to “Registering the Remote test ID”.)
For further information, contact your service representative, an
authorized service center or the place of purchase.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise the cover plate and press the Configure key.
2. Use the cursor up or the cursor down key to select “Remote Diag.”
[“Remote diagn.”].
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select whether to turn
Remote Diagnosis ON or OFF.
* The asterisk (*) in the message display indicates the current
setting.
5. Press the Enter key. The setting for Remote Diagnosis is complete.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Section 6 Various Settings and Registration in this Fax
Remote Diag.:
➪ *On
Off
Set Fax:
2 in 1 RX :Off
Management :Off
➪
Remote Diag. :On
Set Fax:
2 in 1 RX :Off
Management :Off
➪
Remote Diag. :Off
JUL-08-2001 12:00
Set Document
Set Fax:
End
➪
Line Type :Tone Dial
TTI :Outside P.
08-JUL-2001 12:00
Set original
Set fax:
2-up RX :Off
Management :Off
➪
Remote diagn. :Off
Remote diagn.:
➪
On
*Off
Set fax:
2-up RX :Off
Management :Off
➪
Remote diagn. :On
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch) (Metric)
Set fax:
End
➪ TTI :Outside p.
Print report P P