TA Triumph-Adler DC 2020 - Manual (Page 56)

2. Raise the cover plate and press the Duplex Tx. key.
* You can cancel a Duplex Transmission by simply pressing the
Duplex Tx. key again.
3. Enter the destination fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys, program keys, group dial keys or the
directory. Chain dial keys can be used as well.
4. Press the Enter key.
2-2
Section 2 Various Functions of this Fax
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Set the 2-sided documents in the RADF.
Duplex Transmission
Duplex Transmission enables the transmission of both the front
and back sides of duplex (2-sided) documents when the optional
RADF document feeder is installed. Duplex transmission is
always accomplished by setting the documents you want to
transmit in the RADF and scanning them into memory in the
Memory Transmission mode. It is also possible to use Duplex
Transmission capabilities in combination with each of the other
various types of fax communication available in this fax. The
following method explains the procedure for sending duplex
documents to a single destination. * To enable Duplex Transmission, you must select “Standard
size original” when setting the document size for scanning from
the Document Feeder. Duplex Transmission will not be
available if the document size is set to “Long original”.
(Refer to “Setting the Document Size for Scanning from the
Document Feeder”, page 6-9.)
* If you press the Duplex Tx. key during any operation,
Dial Confirmation for one-touch keys will not be available.
It will also be necessary to press the Start key in order to
initiate dialing for abbreviated numbers and one-touch keys.
* In order to schedule a start time for the transmission, press the
Delayed Tx. key at any point in the procedure PRIOR to
entering the destination fax number.
JUL-08-2001 12:00
Set Document
JUL-08-2001 12:00
Document:8 1 / 2 x11
Enter Destination
v :
Document:8 1 / 2 x11
D
Enter Destination
v :35642
Document:8 1 / 2 x11
D
Enter Destination
Cover page:
Yes
➪ No
08-JUL-2001 12:00
Set original
(Inch)
(Metric)
08-JUL-2001 12:00
Document :A4
Enter destination
(Inch)
(Metric)
(Inch) (Metric)
v :
Document :A4
Enter destination
D
(Inch)
(Metric)
v :35642
Document :A4
Enter destination
D
(Inch)
(Metric)