TA Triumph-Adler DC 2020 - Manual (Page 155)

6-15
Setting the Default Transmission
Mode
You can select which transmission mode, Memory Transmission or
Direct Feed Transmission, will be the default setting in this fax.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode
settings.
1. Raise the cover plate and press the Configure key.
2. Use the cursor up or the cursor down key to select “TX
Mode/Default”.
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select the desired
transmission mode.
* The asterisk (*) in the message display indicates the current
setting.
5. Press the Enter key. The setting for the transmission mode is
complete.
* If you are finished making settings, press the Reset key. The
operation panel will return to the initial mode settings.
Section 6 Various Settings and Registration in this Fax
JUL-08-2001 12:00
Set Document
Set Fax:
End
➪
Line Type :Tone Dial
TTI :Outside P.
Set Fax:
Set Volume P P
Scan from ADF :Std size
➪ TX Mode/Default:Memory Tr
Set Fax:
Set Volume P P
Scan from ADF :Std size
➪
TX Mode/Default:Direct Fee
TX Mode/Default:
*Default Feed Transmission
➪
Memory Transmission
08-JUL-2001 12:00
Set original
Set fax:
Set volume P P
DF scanning:Std. orig.
➪
TX mode/Default:Memory Tr
TX mode/Default:
*Default Feed Transmission
➪ Memory Transmission
Set fax:
Set volume P P
DF scanning:Std. orig.
➪ TX mode/Default:Direct Fee
(Inch) (Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
Set fax:
End
➪ TTI :Outside p.
Print report P P