TA Triumph-Adler DC 2020 - Manual (Page 148)

* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise the cover plate and press the Configure key.
2. Use the cursor up or the cursor down key to select “Set Volume”.
3. Press the Enter key.
6-8
Making Volume Settings
The volume of the alarm, the monitor and the speaker can be
adjusted here, or you can make the alarm inaudible.
4. Use the cursor up or the cursor down key to select which volume
setting you want to make.
> If you selected “Buzzer Volume”…
1 Press the Enter key.
2 Use the cursor up or the cursor down key to select the desired
volume.
* The volume can be set to any one of 3 settings: “Off”, “Small”
or “Large”. If you selected “Off”, you will not be able to hear
the alarm.
> If you selected “Monitor Volume”…
1 Press the Enter key.
2 Use the cursor up or the cursor down key to select the desired
volume.
* The volume can be set to any one of 4 settings: “Off”, “Small”,
“Medium” or “Large”. If you selected “Off”, you will not be able
to hear the monitor.
> If you selected “Speaker Volume”…
1 Press the Enter key.
2 Use the cursor up or the cursor down key to select the desired
volume.
* The volume can be set to any one of 4 settings: “Off”, “Small”,
“Medium” or “Large”. If you selected “Off”, you will not be able
to hear the monitor.
5. Press the Enter key.
The message display will return to the “Set Volume” menu.
> If you want to perform other setting procedures, select “End” and
then press the Enter key.
> If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Section 6 Various Settings and Registration in this Fax
Set Volume:
End
➪ Buzzer Volume :Small
Monitor Volume:Medium
JUL-08-2001 12:00
Set Document
Set Fax:
End
➪
Line Type :Tone Dial
TTI :Outside P.
Set Fax:
#Rings(AutoRX): 2Times
Dial Confirm :On
➪ Set Volume P P
Sets the volume of the alarm that sounds in the event of a
communications error or when you press an incorrect key on the
operation panel.
Sets the volume of the internal speaker that allows you to listen to
conditions on the telephone line when the On-Hook key was NOT
pressed.
Sets the volume of the internal speaker that allows you to listen to
conditions on the telephone line when the On-Hook key WAS
pressed.
08-JUL-2001 12:00
Set original
Set fax:
Nr rings-TAD :10Times
Confirm dial :On
➪
Set volume P P
Set Volume:
End
➪ Buzzer Volume :Large
Monitor Volume:Small
Buzzer Volume:
➪ Off
*Small
Large
Speaker Volume:
➪ Off
*Small
Medium
Monitor Volume:
➪
Off
Small
*Medium
(Inch) (Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
Set fax:
End
➪ TTI :Outside p.
Print report P P