TA Triumph-Adler DC 2020 - Manual (Page 20)

1-12
Section 1 Basic Use of this Fax
Press the Enter key.
Registration of your station name is complete.
* To return to the initial mode settings, press the Reset key.
3 Registering your station ID
* Use the following procedure as well when you want to
change information that is already registered.
* If you want to cancel the procedure part way through,
press the Reset key. The operation panel will return to the
initial mode settings.
Perform steps 1 - 4 of “ 1 Registering your fax number”,
page 1-10.
Use the cursor up or the cursor down key to select “Own ID”.
5
1
2
Program Fax Parameter:
End
v :
➪
Own Name :S-Pjt
Program Fax Parameter:
End
➪ v :
Own Name :
Program Fax Parameter:
v :
Own Name :
➪ Own ID :0000
(Inch) (Metric)
Entering your station name
Enter the desired name for your station.
(Refer to “Entering Characters”, page 1-30.)
* Your station name can be up to 32 characters in length.
* The station name registered here will be shown in the
message display of the other party’s fax, as well as on the
Reception Report that they print out. (This function is only
guaranteed to work when the other party’s fax is one of our
models.)
* If you want to clear the currently displayed name from the
message display, simply press the Stop/Clear key.
4
S-Pjt
(Lower case)
Enter Own Name
S-Pjt
(Small letter mode)
Enter own name
(Inch)
(Metric)
(Inch) (Metric)