TA Triumph-Adler DC 2020 - Manual (Page 122)

4-40
Section 4 Other Features of this Fax
(6) Turning Password Check
Reception ON/OFF
Turn Password Check Reception ON when you want to limit from
whom fax communication can be accomplished by turning one or
both of the Password Check Communication modes ON.
(Refer to page 4-35.)
* If there are no Permit Telephone Numbers or Permit IDs registered
in this fax, Password Check Reception will not be possible even if it
is turned ON here.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Perform steps 1 - 3 of “(5) Turning Password Check Transmission
ON/OFF”, page 4-39.
2. Use the cursor up or the cursor down key to select “Receive”.
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select whether to turn
Password Check Reception ON or OFF.
* The asterisk (*) in the message display indicates the current
setting.
5. Press the Enter key. The setting for Password Check Reception is
complete.
6. Use the cursor up or the cursor down key to select “End” and then
press the Enter key.
The message display will return to the “Set Fax” menu.
7. Use the cursor up or the cursor down key to select “End” and then
press the Enter key.
The operation panel will return to the initial mode settings.
Password Check Comm.:
End
Send :Off
➪
Receive :On
Set Fax:
TTI :Outside P.
Print Report P P
➪ Password Check Comm. P P
JUL-08-2001 12:00
Set Document
Password Check Comm.:
End
Send :Off
➪
Receive :Off
Password RX:
➪ On
*Off
Password Check Comm.:
End
➪
Send :Off
Receive :Off
08-JUL-2001 12:00
Set original
Password reception:
➪
On
*Off
(Inch)
(Metric)
(Inch)
(Metric)