RIGOL DS6000 Series - Manual (Page 68)

RIGOL 2 To Set the Vertical System
DS6000 User’s Guide 2-10
Channel Label
You can modify the labels used to mark the analog channels (CH1 to CH4) at the left
side of the screen. The label is the number of the channel (e.g.
) by default and
the length of the modified label can not exceed 4 characters.
Press CH1 Label to enter the label modification interface. As shown in the figure
below:
For example, change “ ” to “
”.
Press Keyboard to select the “Keyboard” area. Select “Aa” using
and press
down to switch it to “ a A”. Select “C” using and press down to input the
character. Use the same method to input “hn1”.
To modify or delete the inputed character, press Name to select the “Name Input
Area” and use
to select the character to be modified or deleted. Reenter the
desired character or press Delete to delete the selected character.
After finishing the input, press OK to finish the modification and the channel label
will change to “
”.
Name Input Area Keyboard Upper-lower Case Switch