RIGOL DS6000 Series - Manual (Page 101)

5 To Trigger the Oscilloscope RIGOL
DS6000 User’s Guide 5-9
Pulse Trigger
Trigger on positive or negative pulse with specified width.
Trigger Type:
Press Type to select “Pulse”. At this point, the trigger setting information as shown in
the figure below is displayed at the upper right corner of the screen.
Source Selection:
Press Source to select CH1-CH4 or EXT as the Trigger Source. The current trigger
source is displayed at the upper right corner of the screen.
Note: select channel with signal input as trigger source to obtain stable trigger.
Pulse Condition:
Press When to select the desired pulse condition.

: trigger when the positive pulse width of the input signal is greater than
the specified Pulse Width.
 : trigger when the positive pulse width of the input signal is lower than the
specified Pulse Width.
 : trigger when the positive pulse width of the input signal is greater than
the specified Lower Limit of Pulse Width and lower than the Upper Limit of Pulse
Width.
 : trigger when the negative pulse width of the input signal is greater than
the specified Pulse Width.
 : trigger when the negative pulse width of the input signal is lower than
the specified Pulse Width.
 : trigger when the negative pulse width of the input signal is greater than
the specified Lower Limit of Pulse Width and lower than the Upper Limit of Pulse
Width.