RIGOL DS6000 Series - Manual (Page 256)

RIGOL 14 Remote Control
DS6000 User’s Guide 14-2
Remote Control via USB
1. Connect the device
Connect the oscilloscope (USB DEVICE) and PC using a USB cable.
2. Install the USB driver
This oscilloscope is a USBTMC device. Assuming that your PC has already been
installed with Ultra Sigma, after you connect the oscilloscope to the PC and turn
both on for the first time (the oscilloscope will be automatically set to USB
interface), the PC will display a New Hardware Wizard as shown in the figure
below. Please install the “USB Test and Measurement Device” driver following
the directions in the wizard. The steps are as follows.
1
2