To set the persistence time, To set the persistence time -3 – RIGOL DS6000 Series User Manual

Page 207

Text mode
Original mode

RIGOL

DS6000 User’s Guide

11-3

To Set the Persistence Time

Press DISP  Persis. Time to set the persistence time of the oscilloscope to Vmin,
specific values (from 50 ms to 20 s) or Infinite.

In the following part, a frequency sweep signal of the sine waveform is used to
demonstrate the waveform effects in different persistence times.

1. Vmin

Enable to view the waveform changing in high refresh rate.

2. Specific Values

Enable to observe glitch that changes relatively slowly or glitch with low
occurrence probability. The persistence time can be set to 50 ms, 100 ms, 200
ms, 500 ms, 1 s, 2 s, 5 s, 10 s or 20 s.